DWX-52D
- 1006-**** The % axis position has been shifted. <DWX-52D>
- 1018-0000 The chucking sensor was not found <DWX-52D>
- 101A-0000 The chucking motor experienced excessive current <DWX-52D>
- 101C-0000 The milling bur sensor was not found <DWX-52D>
- 101D-**** The % milling bur cannot be released <DWX-52D>
- 101E-**** The % milling bur might be broken <DWX-52D>
- 101F-**** The % milling bur chucking has slipped out. <DWX-52D>
- 102D-0000 1029-0000 102A-0000 The spindle cannot be turned, The spindle experienced overcurrent/an overload <DWX-52D>
- Cleaning the Collet for ZS-4D <DWX-52D>
- Cleaning the Collet for ZS-52D <DWX-52D>
- Daily Maintenance <DWX-52D>
- Errors Occur during Automatic Correction <DWX-52D>
- If Milling Accuracy Does Not Improve after Automatic Correction <DWX-52D>
- If the spindle still holds the milling bur and becomes stuck somewhere after powering on... <DWX-52D>
- Maintenance of the Regulator <DWX-52D>
- Option/Supplies/Accessories <DWX-52D>
- Poor quality of the milled surfaces <DWX-52D>
- Printing Errors/Printer Errors/Cannot connect (output) <DWX-52D>
- Procedure for Material Falling from the Pin-Type Workpiece Adapter (Screw Loosening) <DWX-52D>
- Retightening the Collet ZS-4D <DWX-52D>
- Retightening the Collet ZS-52D <DWX-52D>
- Spindle Unit Replacement ZS-4D <DWX-52D>
- Spindle Unit Replacement ZS-52D <DWX-52D>
- The fixing screw has broken. <DWX-52D>
- The margins become thinner than the data. <DWX-52D>
- The Support Pin Is Broken <DWX-52D>
- When automatic correction should be performed. <DWX-52D>
- When the Collet Cannot Be Removed ZS-4D <DWX-52D>