Logo
When the Collet Cannot Be Removed <DWX-4> Manuals and Software Downloads

あなたは歯科医療関係者ですか?

このサイトは日本国内の歯科医師、歯科技工士および歯科衛生士等の歯科医療関係者を対象にしたものであり、一般の方に対する情報提供のサイトではありません。

This message is intended for users in Japan. If you reside outside of Japan and would like to continue, please select “Yes”.

  1. DGSHAPE FAQ EN
  2. Machines
  3. DWX-52D

Maintenance of the Regulator <DWX-52D>

Please regularly drain the compressor and maintain the regulator.

If water accumulates in the compressor or regulator bowl, water droplets can enter the interior of the machine through the air blow.

If water droplets get inside the machine, parts of the machine can rust.

 

 

 

 

 

 

Was this article helpful?
0 out of 0 found this helpful
Return to top

Related articles

  • Daily Maintenance <DWX-52D>
  • Required Compressor Specifications
  • Poor quality of the milled surfaces <DWX-52D>
  • Disc Changer Height Adjustment <DWX-52DCi>
  • Manuals and Software Downloads

Articles in this section

  • 1006-**** The % axis position has been shifted. <DWX-52D>
  • 1018-0000 The chucking sensor was not found <DWX-52D>
  • 101A-0000 The chucking motor experienced excessive current <DWX-52D>
  • 101C-0000 The milling bur sensor was not found <DWX-52D>
  • 101D-**** The % milling bur cannot be released <DWX-52D>
  • 101E-**** The % milling bur might be broken <DWX-52D>
  • 101F-**** The % milling bur chucking has slipped out. <DWX-52D>
  • 102D-0000 1029-0000 102A-0000 The spindle cannot be turned, The spindle experienced overcurrent/an overload <DWX-52D>
  • Cleaning the Collet for ZS-4D <DWX-52D>
  • Cleaning the Collet for ZS-52D <DWX-52D>
See more

Copyright © DGSHAPE FAQ EN. All Rights Reserved

日本語