Logo
When the Collet Cannot Be Removed <DWX-4> Manuals and Software Downloads

あなたは歯科医療関係者ですか?

このサイトは日本国内の歯科医師、歯科技工士および歯科衛生士等の歯科医療関係者を対象にしたものであり、一般の方に対する情報提供のサイトではありません。

This message is intended for users in Japan. If you reside outside of Japan and would like to continue, please select “Yes”.

  1. DGSHAPE FAQ EN
  2. Machines
  3. DWX-51D

1006-**** The % axis position has been shifted. <DWX-51D>

Contact the dealer for data on severe conditions.

 

If errors recur, contact your authorized DGSHAPE/Roland DG Corporation dealer.

Was this article helpful?
0 out of 0 found this helpful
Return to top

Related articles

  • The Support Pin Is Broken <DWX-52D>
  • Override Milling Speed
  • Daily Maintenance <DWX-51D>
  • Spindle Unit Replacement ZS-4D <DWX-51D>
  • The fixing screw has broken. <DWX-52D>

Articles in this section

  • 1006-**** The % axis position has been shifted. <DWX-51D>
  • 101A-0000 The chucking motor experienced excessive current <DWX-51D>
  • 101C-0000 The milling bur sensor is not found <DWX-51D>
  • 102D-0000 1029-0000 102A-0000 The spindle cannot be turned, The spindle experienced overcurrent/an overload <DWX-51D>
  • Daily Maintenance <DWX-51D>
  • Printing Errors/Printer Errors/Cannot connect (output) <DWX-51D>
  • Procedure for Material Falling from the Pin-Type Workpiece Adapter (Screw Loosening) <DWX-51D>
  • Spindle Unit Replacement ZS-4D <DWX-51D>
  • The fixing screw has broken. <DWX-51D>

Copyright © DGSHAPE FAQ EN. All Rights Reserved

日本語