The margins become thinner than the data. <DWX-42W>
◆ Is the milling bur worn? Replace the milling bur and try milling again.
Milling burs are consumables.
Even within the replacement time of the milling bur, its wear may be accelerated due to milling conditions and the type of material. If the milling bur is used until it breaks, the load on the spindle, collet and motors will be higher, potentially increasing machine problems.
◆ Check if the material is wobbling.
If the pin-type workpiece is loose, retighten the screw.
Replacement is requested if the adaptor or screw is deformed. You can order it from your authorized DGSHAPE/Roland DG Corporation dealer.
ZV-42W
◆ Please review the milling data.
Contact the dealer for data on severe conditions.
◆ Check the parts that grip the milling bur, such as the chuck and the collet, for any milling waste.
Detach the collet and clean the inside.
Reference video
◆ Collet deformation, cracks, chipping
Replace the collet. The collet is a consumable.
*The collet should be ordered from your dealer in the same way as the milling bur.
*Brand-new spindle is supplied with a collet.
◆ Machine Installation Conditions
If the table on which the machine is installed is not stable, chipping may be more likely to occur due to the machine rocking.